10 key process steps of chip manufacturing

Jun 25, 2021

Leave a message

1. Deposition


  The first step in manufacturing a chip is usually to deposit a thin film of material on the wafer. The material can be a conductor, an insulator, or a semiconductor.


  2, photoresist coating


  Before photolithography, the photosensitive material "photoresist" or "photoresist" is first coated on the wafer, and then the wafer is placed in the lithography machine.


   3. Exposure


   Make the pattern blueprints that need to be printed on the reticle. After the wafer is placed in the lithography machine, the light beam is projected onto the wafer through the reticle. The optical elements in the lithography machine shrink and focus the pattern onto the photoresist coating. Under the irradiation of the light beam, the photoresist undergoes a chemical reaction, and the pattern on the photomask is thus imprinted on the photoresist coating.


   4. Computational lithography


   The physical and chemical effects generated during photolithography may cause pattern deformation, so it is necessary to adjust the pattern on the reticle in advance to ensure the accuracy of the final photolithography pattern. ASML integrates existing lithography data and wafer test data to create algorithm models and precisely adjust patterns.


   5. Baking and developing


  After the wafer leaves the lithography machine, it must be baked and developed to make the lithography pattern permanently fixed. Wash away the excess photoresist, leaving a blank part of the coating.


  6, etching


   After the development is completed, use gas and other materials to remove the excess blank parts to form a 3D circuit pattern.


  7, measurement and inspection


  During the chip production process, the wafers are always measured and inspected to ensure that there are no errors. The inspection results are fed back to the lithography system to further optimize and adjust the equipment.


   8. Ion implantation


  Before removing the remaining photoresist, the wafer can be bombarded with positive or negative ions to adjust the semiconductor characteristics of part of the pattern.


   9. Repeat the process steps as needed


  From film deposition to removal of photoresist, the whole process covers the wafer with a pattern. To form an integrated circuit on a wafer to complete chip production, this process needs to be repeated continuously, up to 100 times.


  10, packaged chip


  The last step is to cut the wafer to obtain a single chip, which is packaged in a protective case. In this way, the finished chip can be used to produce TVs, tablets or other digital devices!



If  you are interedted in our products, please visit www.hkram.com to have more information.