Circuit use and circuit safety to choose the right switch

Nov 19, 2019

Leave a message

Rotary switches are mainly installed on liquid and gas pipelines to regulate the flow and pressure of liquids and gases. When in use, turn the handle to drive the adjustment nut to rotate, connect the valve with the left-hand thread through the left-hand thread, and drive the valve to the right or left to change the cross-sectional area of the right hole passage in the valve body cavity, thereby adjusting the liquid and gas in the upper outlet pipe. Flow and pressure.

Common band switches and shift switches of multimeters are rotary switches. There are two types of structures: one is the BBM (Break Before Make) contact type. After the contact is turned on again, there is a state where it is disconnected from both the front and back contacts: the other is the MBB (Make Before Break) contact type, which is characterized in that the moving contact has a state that it is in contact with both the front and back contacts during transposition. . Then disconnect the front contact and maintain contact with the rear contact. In the circuit design, the appropriate rotary switch should be selected according to the purpose of the circuit and the safety of the circuit.