The main component of the infrared sensor switch is a pyroelectric infrared sensor. The human body has a certain body temperature, usually 36-37 degrees, so it emits infrared rays of a specific wavelength. The 9.5um infrared rays emitted by the human body are enhanced by the Fresnel lens to gather infrared rays. As for the induction source, the infrared induction source usually adopts a pyroelectric infrared sensor. This kind of element will lose the charge balance when the temperature of the infrared radiation of the human body changes, and the charge will be released outward. The subsequent circuit can trigger the switching action after the detection and processing.
Install and use
1. During installation, no live wiring is allowed, and load short circuit is strictly prohibited. For products that control fluorescent lamps and energy-saving lamps, it may take 30 to 60 seconds for the internal voltage to establish time for the switch to work normally when it is powered on for the first time.
2. Due to the large starting current of fluorescent lamps and energy-saving lamps, it is recommended that one switch control less than 2 loads.
3. Do not install the product in a place where there is hot air flow. If the control load is heating, it should be greater than 1 meter.
4. 2-wire products without neutral line and emergency control do not have to consider the wiring polarity. Products with emergency control or neutral line must be wired as shown in the diagram (no emergency control product EM terminal is not wired).
5. When adjusting the light control illuminance and delay time knobs, you should use moderate force. Excessive force may cause damage to the product.
If you are interested in our products, please visit
www.hkram.com to have more information.








