Knife switches used only for power isolation do not require an arc extinguishing device. High current knife switches used in electrolysis, electroplating and other equipment can be rated up to tens of thousands of amperes. This type of knife switch generally adopts a multi-loop conductor parallel structure, and can dissipate heat by water cooling to increase the current density that the knife switch conductor can carry.
The knife switch is required to be able to withstand the electric force and heat generated by the short-circuit current in the circuit. Therefore, in the structural design of the knife switch, it must be ensured that under the action of a large short-circuit current, the contact knife will not spring, weld or burn. For the knife switch that needs to cut off the load current, it is equipped with an arc extinguishing device such as a fast blade or an arc extinguishing chamber.
According to the number of poles, the knife switch can be divided into single pole knife switch, double pole knife switch and three pole knife switch. According to the conversion method, it can be divided into single throw knife switch and double throw knife switch. According to the operation mode, it can be divided into handle direct operation. And lever knife switches. Figure 1 shows the circuit diagram of a three-pole single-throw knife switch. It can be used to switch on or off circuit A, and it can also be used to isolate circuit A from the power supply. Figure 2 is a single-pole double-throw knife switch. It can be used to switch on or off circuit A or circuit B, and it can also convert power from circuit A to circuit B.
The transfer switch is used in the main circuit to transfer one group of connected devices to another group of connected devices.
1. Isolate the power supply to ensure the safety of circuit and equipment maintenance; or to load and disconnect the load below the rated current infrequently.
2. Disconnect the load, such as switching on and disconnecting low-voltage circuits with small capacity or starting small-capacity motors infrequently.
3. When the knife switch is in the off position, it can be clearly observed to ensure the safety of the circuit maintenance personnel.








